IT-E255A/M Quick Charger Controller

ITECH IT255A/M quick charger controller provides QC2.0, QC3.0, QC4.0, PE+, PE2.0+, USB PD2.0 and USB PD3.0/USB PPS 7 types of protocols for automatically or manually quick charger loading test.

It can simulate the fast charge control signal of smartphone, tablet, and notebook, which is suitable for the test of smartphone/tablet charger, AC-DC adapter, mobile power bank, car charger and wall charger.

Product Features

DUT

♦ Smartphone/tablet charger, AC-DC adapter

♦ Mobile power bank

♦ Car charger

♦ Wall charger

IT-E255M Quick charger controller (Manual)

IT-E255M is manual version with big LED screen, which can support IT8500+, IT8800, IT8700 electronic loads connection and simulate the loading of quick charger.

Both provide a Micro USB and a USB Type C hardware interface for DUT connection.

IT-E255A Quick charger controller (Automatic)

IT-E255A is automatic version with big LED screen, which can connect to IT8500+ electronic load via TTL interface. It can be controlled by PC software via USB interface and be offline controlled whenever needed.

IT-E255A Automatic Test

IT-E255A controlled by PC software can fulfill all the functions of Quick charger controller and partial functions of e-load, including list, OCP/ OPP test and comparison.

Programs can be written into the Quick charger controller; thus, the Quick charger controller can do mass production test without the PC.

1. Communication test: connect USB to PC and open the device manager. If it shows USB Test and Measurement Device(IVI), then it works. Or you can use USB Charger Software to check.

2. The software can be connected by RS232 or USB port.

3. Enter 'list mode' and carry out steps operation and comparison. The OCP and OPP test of chargers can be done step by step.

4. If operation offline, choose write and download the program to the quick charger controller. Then the simple test can be done automatically by operation on the front panel.

Functions and Advantages

Quick Charge 2.0 and 3.0 quick charger technology

Quick Charge 2.0 is the2.0 version of quick charging technology which was developed by Qualcomm. When the mobile devices such as mobile phone, tablet and chargers are compliance with QC2.0 protocol, the charger can receive the order of these mobile devices. The output power of charger can be increased and the quick charging to battery can be carried out.

Quick Charge 3.0 ( QC3.0 ) is the next generation technology. The key improvement of this version is to replace the manage system of ‘fixed voltage’ by ‘INOV’( Intelligent Negotiation for Optimum Voltage ). The started input voltage can be 3.6V. The unit can be 0.2V(200Mv）. Adjust it based on real time batter temperature, transformation efficiency, capacity and so on. It can increase or decrease gradually within the voltage range allowed (9V or 12V ).

At present, QC2.0、QC3.0 have been adopted by many manufacturers like Samsung, MI, Motorola, Google, Soni, etc. The technology can be applied to many products including mobile phone, charger, power bank, car charger and even drone. Now it has its own eco chain already.

When carrying out QC2.0test, IT-E255 A/M can simulate four different output voltage(5V、9V、12V、20V) and the maximum power is 18W. When carrying out QC3.0 test, the controller can do load test from 3.6V to 20V with0.2V step increase.